Load data for .30 PICRA + .308 | 165gr | Brenneke TOG

Recommended Powder(s): none

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.308 \| 165gr \| Brenneke TOG
Bullet Weight:	165gr \| 10.7g
Bullet Diameter:	0.308" \| 7.82mm
Bullet Length:	1.183" \| 30.0mm
Caliber:	.30 PICRA load data
Case Length (l3):	1.291" \| 32.8mm
Cartridge Length (C.O.L.):	2.172" \| 55.2mm
Seated Depth:	0.302" \| 7.7mm
Shank Seated Depth:	0.245" \| 6.2mm
Case Capacity:	24.2 Grains of Water \| 1.57 cm³
Primer Size:	Small Pistol (SP)
Max. allowed Pressure:	40611 psi \| 2800 bar
LID:	LID_B1175_C311
Last updated:	2025-01-01
Recommended Twist Rate:	1:12 - 1:10

Load data for 46 loads in caliber .30 PICRA with .308 | 165gr | Brenneke TOG bullet and 23 powders such as none. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	71%	34563	85%	**78	100%
ADI APS 450	<<locked>>	64%	36492	90%	**1	100%
Accurate 4100	<<locked>>	73%	36013	89%	**83	92%
[Accurate No. 11 FS]*	<<locked>>	81%	35447	87%	**83	85%
Accurate No. 9	<<locked>>	63%	36521	90%	**73	97%
Alliant 2400	<<locked>>	70%	36434	90%	**93	95%
Alliant BLUE DOT	<<locked>>	72%	35708	88%	**53	99%
[Hodgdon H110]*	<<locked>>	78%	35998	89%	**19	89%
Hodgdon LilGun	<<locked>>	78%	34679	85%	**25	95%
Hodgdon TrailBoss	<<locked>>	96%	25556	63%	**6	100%
Maxam CSB 1	<<locked>>	64%	35317	87%	**56	100%
Ramshot Enforcer	<<locked>>	69%	35476	87%	**83	96%
ReloadSwiss RS 14	<<locked>>	97%	24947	61%	**2	100%
ReloadSwiss RS 30	<<locked>>	95%	36114	89%	**42	92%
SNPE Vectan A0	<<locked>>	64%	36419	90%	**99	100%
SNPE Vectan BA6 1/2	<<locked>>	95%	35230	87%	**73	97%
SNPE Vectan BA7 1/2	<<locked>>	66%	34795	86%	**38	100%
[Somchem S265]*	<<locked>>	86%	36521	90%	**73	88%
Vihtavuori 3N38	<<locked>>	68%	34969	86%	**17	100%
Vihtavuori N105	<<locked>>	72%	35592	88%	**40	100%
Vihtavuori N110	<<locked>>	86%	34548	85%	**86	95%
Vihtavuori N32C Tin Star	<<locked>>	79%	36187	89%	**1	100%
[Winchester 296]*	<<locked>>	78%	36332	89%	**32	86%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	26324	65%	**63	100%
ADI APS 450	<<locked>>	60%	33852	83%	**8	100%
[Accurate 4100]*	<<locked>>	61%	24294	60%	**93	85%
[Accurate No. 11 FS]*	<<locked>>	75%	28456	70%	**81	81%
Accurate No. 9	<<locked>>	61%	34301	84%	**50	96%
Alliant 2400	<<locked>>	61%	27093	67%	**48	90%
Alliant BLUE DOT	<<locked>>	61%	26310	65%	**12	96%
[Hodgdon H110]*	<<locked>>	65%	23482	58%	**02	81%
[Hodgdon LilGun]*	<<locked>>	61%	19043	47%	**43	83%
Hodgdon TrailBoss	<<locked>>	60%	13373	33%	**6	100%
Maxam CSB 1	<<locked>>	61%	32851	81%	**27	100%
Ramshot Enforcer	<<locked>>	61%	26614	66%	**42	91%
ReloadSwiss RS 14	<<locked>>	61%	13329	33%	**6	100%
[ReloadSwiss RS 30]*	<<locked>>	77%	22060	54%	**89	82%
SNPE Vectan A0	<<locked>>	61%	33924	84%	**76	100%
[SNPE Vectan BA6 1/2]*	<<locked>>	61%	13982	34%	**3	81%
SNPE Vectan BA7 1/2	<<locked>>	61%	30603	75%	**89	100%
[Somchem S265]*	<<locked>>	71%	23960	59%	**70	80%
Vihtavuori 3N38	<<locked>>	61%	28689	71%	**29	99%
Vihtavuori N105	<<locked>>	60%	25237	62%	**96	100%
[Vihtavuori N110]*	<<locked>>	61%	16462	41%	**1	81%
Vihtavuori N32C Tin Star	<<locked>>	61%	24961	61%	**0	100%
[Winchester 296]*	<<locked>>	71%	29196	72%	**17	81%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data